CFM-2 Accessories Behringer

ULTRAGLIDE CROSSFADER MODULE CFM-2

All electro-mechanical parts eventually wear down, especially the crossfaders on mixers - they undergo the wear and tear of heavy use. Our Crossfader Module gives mixers a second life. This replacement part protects the performance quality and the value of your favorite musical tool. You can even use the crossfader module to upgrade a second-hand mixer. The CFM-2 Crossfader Module is designed to extend the lifespan of your BEHRINGER DJ mixer for many more years of the flawless performance – you’ve come to rely on. The high-quality CFM-2 Crossfader Module is the ideal replacement (4-pin cable connector only) for the following: VMX1000 VMX300 VMX200 DJX700 DJX400 DX626 DX052

WARNING You must remove the cover of your BEHRINGER unit to add/exchange the crossfader. Electrical current from power cables can be hazardous. DO NOT REMOVE THE COVER OF YOUR BEHRINGER UNIT UNLESS YOU ARE QUALIFIED TO DO SO. To avoid personal injury or equipment damage, disconnect the attached power cords before you open the unit cover. Do not operate the BEHRINGER unit without the cover in place. Failure to take these precautions may result in personal injury and system damage. CAUTION Do not make mechanical or electrical modifications to the equipment. BEHRINGER is not responsible for regulatory compliance of a modified BEHRINGER product. If you are not confident of your own ability to perform this action, then please contact one of our authorised service centres or the dealership from where the unit was purchased.