S

Please Navigate to: http://www.tracktion.com/

Before you begin make sure you have the latest Drivers and Firmware installed which are downloadable from our website here: www.behringer.com/EN/Products/FCA1616.aspx(click the Downloads tab and scroll down).

It is possible to calibrate certain aspects of your Deepmind from the "System settings" menu. To get to the system Settings, Press the "GLOBAL" button until you arrive at this menu, and towards the bottom you should see the "CALIBRATE" option.

X-TOUCH - How do I enter the Self Test Mode?

Some XENYX mixers come with a built in effects unit, here is a list of the effect presets installed on each unit: FX Series XENYX 1002FX- http://www.behringer.com/assets/1002FX_P0572_V_YY.pdf XENYX 1202FX- http://www.behringer.com/assets/1202FX_P0571_V_YY.pdf

How do I configure my XR18/X18 or MR18 to playback signal from my computer?

Using a TOSLINK cable, connect the ADAT in of your UMC1820 to the ADAT out of the additional device, and the ADAT out of the additional device to the ADAT in of the UMC1820.

Before performing the reset, we would always recommend that you backup your device's settings via a Sysex Dump. Steps on how to do this can be found at the following link.

For this guide we are using the Ampkit 2.2 App on the Behringer iStudio202 with an iPad 3. We have connected a midi cable from the MIDI Out/Thru on the FCB1010 to the MIDI input of the iStudio202. This programming and connection method can be used for all MIDICC compatible devices and software.

When updating the unit on a Windows computer, you may encounter an error stating Update Failed: Cannot communicate with the Neutron. Please check you have the right driver installed.