|
ACOUSTICAL1
|
|
Operating Frequency Range2
|
55 Hz – 20 kHz
|
|
Frequency Response3
|
66 Hz – 18 kHz ±4 dB
|
|
Phase Response
|
750 Hz – 18 kHz ±45 degrees
|
|
Linear Peak SPL4
|
125 dB with 18 dB crest factor (M-noise), 122.5 dB (Pink noise), 125 dB (B‑noise)
|
|
COVERAGE5
|
|
|
50° x 80° or 80° x 50° (rotatable horn)
|
|
TRANSDUCERS
|
|
Low Frequency
|
One 10‑inch cone driver; 4 & OMEGA; nominal impedance
|
|
High Frequency
|
One 3‑inch diaphragm compression driver; 16 Ω nominal impedance
|
|
AUDIO INPUT
|
|
Type
|
Differential, electronically balanced
|
|
Maximum Common Mode Range
|
±15 V DC, clamped to earth for voltage transient protection
|
|
Connectors
|
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio)
|
|
Input Impedance
|
10 kΩ differential between positive (+) and negative (–) audio pins
|
|
Wiring6
|
Phoenix 5‑pin Male Pin 1: DC Power (‑) Pin 2: DC Power (+)
Pin 3: Chassis/earth through
1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 4: Audio (‑)
Pin 5: Audio (+)
|
SwitchCraft EN3 5‑pin Male Pin 1: DC Power (‑)
Pin 2: DC Power (+)
Pin 3: Chassis/earth through
1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 4: Audio (‑)
Pin 5: Audio (+)
|
ECO‑M 7‑pin Male5 Pin 1: DC Power (‑) Pin 2: DC Power (+)
Pin S: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 5: Audio (‑)
Pin 6: Audio (+)
|
|
Nominal Input Sensitivity
|
0 dBV (1.0 V rms) continuous is typically the onset of limiting for noise and music
|
|
Input Level
|
Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.
|
|
AMPLIFIER
|
|
Type
|
2‑channel, Class‑D
|
|
Total Output Power7
|
550 W peak
|
|
THD, IM, TIM
|
< 0.02%
|
|
Cooling
|
Convection
|
|
DC POWER
|
|
Connector
|
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio)
|
|
Safety Rated Voltage Range
|
48 V DC
|
|
RMS NETWORK (OPTIONAL ON REQUIRED MPS-488HP POWER SUPPLY))
|
|
|
Equipped with two‑conductor twisted‑pair network, reporting all operating parameters of amplifiers to system operator’s host computer.
|