FAQs

- Page 19
  How do I calibrate my device?
It is possible to calibrate certain aspects of your Deepmind from the "System settings" menu. To get to the system Settings, Press the "GLOBAL" button until you arrive at this menu, and towards the bottom you should see the "CALIBRATE" option.
X-TOUCH - How do I enter the Self Test Mode?
X-TOUCH - How do I enter the Self Test Mode?
Where Can I Find A List Of Effects Built In mixer?
Some XENYX mixers come with a built in effects unit, here is a list of the effect presets installed on each unit: FX Series XENYX 1002FX- http://www.behringer.com/assets/1002FX_P0572_V_YY.pdf XENYX 1202FX- http://www.behringer.com/assets/1202FX_P0571_V_YY.pdf
How do I connect my X32 mixer to X32 Edit?
The X32 application can be used to control the X-32 over a network. In order to achieve this, both the X32 and the computer you wish to control it with need to be connected to the same network. This can be achieved by either connecting them directly with an Ethernet cable, or by connecting them both to the same router.
Why can’t I hear the playback from my computer using the UMC404HD or UMC1820?
Why can’t I hear the playback from my computer using the UMC404HD or UMC1820
How do I configure my XR18/X18 to playback signal from my computer?
How do I configure my XR18/X18 or MR18 to playback signal from my computer?
How do I use ADAT inputs and outputs?
Using a TOSLINK cable, connect the ADAT in of your UMC1820 to the ADAT out of the additional device, and the ADAT out of the additional device to the ADAT in of the UMC1820.
Why does my UMC interface make noise when powering on and off?
When the UMC powers on, whether via USB bus or Power supply the on board DSP will emit a noise which cannot be stopped.
How do I factory reset my unit?
Before performing the reset, we would always recommend that you backup your device's settings via a Sysex Dump. Steps on how to do this can be found at the following link.