S

How do I configure my XR18/X18 or MR18 to playback signal from my computer?

Using a TOSLINK cable, connect the ADAT in of your UMC1820 to the ADAT out of the additional device, and the ADAT out of the additional device to the ADAT in of the UMC1820.

Before performing the reset, we would always recommend that you backup your device's settings via a Sysex Dump. Steps on how to do this can be found at the following link.

For this guide we are using the Ampkit 2.2 App on the Behringer iStudio202 with an iPad 3. We have connected a midi cable from the MIDI Out/Thru on the FCB1010 to the MIDI input of the iStudio202. This programming and connection method can be used for all MIDICC compatible devices and software.

When updating the unit on a Windows computer, you may encounter an error stating Update Failed: Cannot communicate with the Neutron. Please check you have the right driver installed.

The Concept Firstly we need to understand the concept of the 'OUT 1-16' bus within the X32. This is not a physical bus, it is better thought of as a virtual bus inside the X32 architecture that can act as a virtual patch Bay of sorts. Which allows us to connect pretty much any signal and specific point of that signal's path to the required physical bus or output.

1. Copy and Paste functions can be accessed from the UTILITY button.

Once you have got your X Touch connected with your DAW in Mackie emulation mode, controlling your plugins is a simple matter. Simply press the ‘SELECT’ button on the channel with plugins which you wish to control, and press the ‘PLUG-IN’ button in the Encoder Assign section at the top right corner of the console.

This could be down to the fact that the USB port is already assigned for another purpose and plugging the mixer in is causing a conflict.

The firmware on this unit can is updated using the SynthTool. The latest version of the SynthTool can be found on the link below: