(1) Computer mechanically modeled cabinet design using Low resonance Integral Molding™ (LRIM™) materials
- Wooden cabinet with a tough painted finish and high density rubber isolating feet
- Excellent self-damping properties leading to minimal cabinet resonances
- No standing wave resonances inside cabinet
- Reduced cabinet resonances
(2) In-house modelled long-throw composite sandwich cone bass driver with Extremely Linear Force Factor™ (ELFF™), magnetic shielding, flow optimized die cast basket and robust built-in grille
- Damping of break up modes brings low distortion at high sound levels
- Linear pistonic motor gives a very low harmonic distortion even at high excursions
- Reduced air noise and improved rocking modes
- Grille protects against mechanical damage
(3) Large high-capacity flow-optimized bass reflex ports
- Fast bass transient response
- Reduced bass compression at high output levels
- Can be flush mounted
(4) 2.0/ 0.1 Bass Management
- Stereo and externally bass managed applications
- Bypassable 4th order 80 Hz active crossover for maximum compatibility with consumer reproduction systems
- Allows main loudspeakers to play louder and with lower distortion
(5) Four routing modes
- Right channel bass management
- LFE to subwoofer only up to 120 Hz
- Wide for multichannel systems where the bass management is in the source
- Daisy chain for subwoofer arrays
(6) XLR electronically balanced analogue inputs and outputs
- Standard interfacing to professional equipment
- Daisy chain output for subwoofer arrays
(7) Wide range input gain and output level controls
- Easier interfacing with signal sources
8-position phase control, continuous low cut control and parametric equalizer
- More control in diverse acoustical environments
- Parametric equalizer is bypassable if not needed
(8) Universal switched-mode power supply (100 … 240 V)
- One version works in any country and robust to poor quality mains supply
(9) Ground lift
- Reduced noise in electrically noisy environments and over-comes ground loops
(10) Low heat dissipation amplifiers with large headroom and overheat limiting
- Improved transient response
- Assured reliability and safety
Separate fast acting thermo limiter to protect the voice coil and power amplifier
- Soft clip and excursion limiters
- Increases system reliability
- Allows extraction of the maximum performance from the system
(11) Installation flexibility
- Remoteable electronics (REK 3) for ease of installation, less cabling, and convenience of use