LEO Loa Full đôi 15" Line Array Meyer Sound

ACOUSTICAL1

Operating Frequency Range2

55 Hz – 16 kHz

Phase Response

375 Hz – 14 kHz ±30°

Linear Peak SPL3

149.5 dB with 20 dB crest factor (M‑noise), 142.5 dB (Pink noise), 144 dB (B‑noise)

COVERAGE

Horizontal Coverage

75°

Vertical Coverage

Varies, depending on the array length and configuration

TRANSDUCERS

Low Frequency

Two 15‑inch long‑excursion cone drivers; 4 Ω nominal impedance

High Frequency

Two 4‑inch diaphragm compression drivers coupled to a constant‑directivity horn through a patented REM manifold; 12 Ω nominal impedance

AUDIO INPUT

Type

Differential, electronically balanced

Maximum Common Mode Range

±15 V DC, clamped to earth for voltage transient protection

Connectors

XLR 5‑pin female input with male loop output

Input Impedance

10 kΩ differential between pins 2 and 3

Wiring

Pin 1: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamped network to provide virtual ground lift at audio frequencies

Pin 2: Signal + Pin 3: Signal ‑ Pin 4: RMS

Pin 5: RMS

Case: Earth ground and chassis

Nominal Input Sensitivity

0 dBV (1 V rms) continuous is typically the onset of limiting for noise and music

Input Level

Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker

AMPLIFIERS

Type

3‑channel complementary MOSFET output stages (class AB/H bridged)

Total Output Power4

9900 W Peak

THD, IM, TIM

< 0.02%

Cooling

Two ultra high‑speed primary fans, two ultra high‑speed reserve fans

AC POWER

Connector

powerCON 32

Automatic Voltage Selection

208–235 V AC, 50–60 Hz

Safety Rated Voltage Range

208–235 V AC, 50–60 Hz

Turn‑on and Turn‑off Points

Turn‑on: 165 V AC; Turn‑off: 264 V AC

CURRENT DRAW

Idle Current

0.6 A rms (230 V AC)

Max Long‑Term Continuous Current (>10 sec)

6.0 A rms (230 V AC)

Burst Current (<1 sec)5

8.0 A rms (230 V AC)

Maximum Instantaneous Peak Current

24 A peak (230 V AC)

Inrush Current

< 15 A peak