|
ACOUSTICAL1
|
|
Operating Frequency Range2
|
75 Hz – 20 kHz
|
|
Frequency Response3
|
80 Hz – 16 kHz ±4 dB
|
|
Phase Response
|
300 Hz – 18 kHz ±60 degrees
|
|
Linear Peak SPL4
|
118.5 dB with crest factor >14 dB (M-noise), 113 dB (Pink noise), 115.5 (B‑noise)
|
|
COVERAGE
|
|
Horizontal Coverage
|
100°
|
|
Vertical Coverage
|
100°
|
|
TRANSDUCERS
|
|
Low Frequency
|
Two 5‑inch cone drivers; 8 & OMEGA; nominal impedance
|
|
High Frequency
|
One 1‑inch metal dome tweeter; 8 Ω nominal impedance
|
|
AUDIO INPUT
|
|
Type
|
Differential, electronically balanced
|
|
Maximum Common Mode Range
|
±15 V DC, clamped to earth for voltage transient protection
|
|
Connectors
|
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio)
|
|
Input Impedance
|
10 kΩ differential between positive (+) and negative (–) audio pins
|
|
Wiring5
|
Phoenix 5‑pin Male Pin 1: DC Power (‑) Pin 2: DC Power (+)
Pin 3: Chassis/earth through
1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 4: Audio (‑)
Pin 5: Audio (+)
|
SwitchCraft EN3 5‑pin Male Pin 1: DC Power (‑)
Pin 2: DC Power (+)
Pin 3: Chassis/earth through
1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 4: Audio (‑)
Pin 5: Audio (+)
|
ECO‑M 7‑pin Male5 Pin 1: DC Power (‑) Pin 2: DC Power (+)
Pin S: Chassis/earth through
1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 5: Audio (‑)
Pin 6: Audio (+)
|
|
Nominal Input Sensitivity
|
–8.0 dBV (0.4 V rms) continuous average is typically the onset of limiting for noise and music
|
|
Input Level
|
Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.
|
|
AMPLIFIER
|
|
Type
|
3‑channel, class D
|
|
Total Output Power6
|
650 W peak
|
|
THD, IM, TIM
|
< 0.02%
|
|
Cooling
|
Convection
|
|
DC POWER
|
|
Connector
|
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio)
|
|
Safety Rated Voltage Range
|
48 V DC
|
|
RMS NETWORK (OPTIONAL)
|
|
|
Equipped with two‑conductor twisted‑pair network, reporting all operating parameters of amplifiers to system operator’s host computer.
|