Lyon Loa Line Array đôi 12" Meyer Sound

ACOUSTICAL1

LYON-M

LYON-W

LYON-WXT

Operating Frequency Range2

55 Hz – 16.5 kHz

Phase Response

80 Hz – 16 kHz ±30°

Linear Peak SPL3

143.5 dB with crest factor >17.5 dB (M-noise),
137.5 dB (Pink noise),
140 dB (B-noise)

143.5 dB with crest factor >17.5 dB (M-noise),
136.5 dB (Pink noise), 138.5 dB (B-noise)

143.5 dB with crest factor> 17.5 dB (M-noise), 136.5 dB (Pink noise), 138.5 dB (B-noise)

COVERAGE

LYON-M

LYON-W

LYON-WXT

Horizontal Coverage

90°

110°

110°

Vertical Coverage

Varies, depending on array length and configuration; LYON-WXT has extended vertical coverage.

TRANSDUCERS

Low Frequency

Two 12-inch long-excursion cone drivers; 4 Ω nominal impedance

High Frequency

Two 3-inch diaphragm compression drivers coupled to a constant-directivity horn through a patented REM manifold; 16 Ω nominal impedance

AUDIO INPUT

Type

Differential, electronically balanced

Maximum Common Mode Range

±15 V DC, clamped to earth for voltage transient protection

Connectors

XLR 5-pin female input with male loop output; XLR 3-pin female connectors available to accommodate only balanced audio (no RMS signals)

Input Impedance

10 kΩ differential between pins 2 and 3

Wiring4

Pin 1: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamped network to provide virtual ground lift at audio frequencies

Pin 2: Signal +
Pin 3: Signal -
Pin 4: RMS
Pin 5: RMS
Case: Earth ground and chassis

Nominal Input Sensitivity

0 dBV (1 V rms) continuous is typically the onset of limiting for noise and music

Input Level

Audio source must be capable of producing of +20 dBV (10 V rms) into 50 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker.

AMPLIFIERS

Type

3-channel complementary MOSFET output stages (class AB/H bridged)

Total Output Power5

8500 W peak

THD, IM, TIM

< 0.02%

Cooling

Two ultra high-speed primary fans; two ultra high-speed reserve fans

AC POWER

Connector

powerCON 32

Automatic Voltage Selection

95–125 V AC, 50–60 Hz; 208–235 V AC, 50–60 Hz

Safety Rated Voltage Range

100-240 V AC, 50–60 Hz

Turn-on and Turn-off Points

Turn-on: 85 V AC; Turn-off: 134 V AC; Turn-on: 165 V AC; Turn-off: 264 V AC

CURRENT DRAW

Idle Current

1.2 A rms (115 V AC); 0.6 A rms (230 V AC); 0.7 A rms (208 V AC)

Max Long-Term Continuous Current (>10 sec)

11.2 A rms (115 V AC); 5.6 A rms (230 V AC); 6.2 A rms (208 V AC)

Burst Current (<1 sec)6

15.4 A rms (115 V AC); 7.5 A rms (230 V AC); 8.2 A rms (208 V AC)

Maximum Instantaneous Peak Current

45 A peak (115 V AC); 23 A peak (230 V AC); 25 A peak (208 V AC)

Inrush Current

< 15 A peak

RMS NETWORK

Equipped with two-conductor, twisted-pair network; reports all amplifier operating parameters to host computers

PHYSICAL

Dimensions

W: 38.15 in (969 mm) x H: 14.85 in (377 mm) x D: 21.00 in (533 mm)

Weight

199 lbs (90.3 kg)

Enclosure

Premium multi-ply birch, slightly textured black finish

Protective Grille

Powder-coated, hex-stamped steel with acoustical black mesh

Rigging

End frames with captive GuideALinks secured with 0.4375 in x 0.090 in quick-release pins that allow 0.5°–9° splay angles (8°–15° splay angles support with LYON WXT); Detachable side handles